From a scrap piece of ash I cut the four seat hangers, drilled 1/4 inch holes through the length of them. I then drilled 1/4 inch holes through the gunwales taking care to be sure that they were as close to verticle as possible. The location of the holes in the gunwales is very important. If they are out of whack then your seat will not bolt in properly.
Saturday, March 29, 2008
Canoe
From a scrap piece of ash I cut the four seat hangers, drilled 1/4 inch holes through the length of them. I then drilled 1/4 inch holes through the gunwales taking care to be sure that they were as close to verticle as possible. The location of the holes in the gunwales is very important. If they are out of whack then your seat will not bolt in properly.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment